draft angle的意思

draft angle中文翻譯：

煙囪錐度

拔模角，[機]模鍛斜度；拔模角度，[機]拔模斜度

相似詞語短語

draftable───adj.可征召入伍的

rake angle───傾角；刀面角；投彈角

seat angle───支座角鋼；閥座傾斜角

secant angle───割線角

straight angle───n.[數]平角

craft knife───n.美工刀

detangle───v.理順（頭發）

雙語使用場景

upper die of the new type of finish forging die so that pattern draft Angle of half axle of forging is small oversize for machining is little.───新型精壓模的上模設有頂件裝置鍛件半軸的拔模斜度小鍛件半軸的金屬敷料少。

Design: adopt small draft Angle to reduce soldering, avoid sharp corner to reduce crack, optimize runner system to reduce erosion.───設計：選用小的脫模角度減少粘焊，避免尖角應力造成開裂，優化流道設計減少沖蝕…更多。

red highlighted area has a problem of a small draft angle, we suggest enlarging the draft to avoid causing drag marks on the part.───紅色顯示的部位拔模角度太小，我們建議加大拔模角來防止產品拉傷。

The forging die has no draft angle and the material utilization rate is increased about 12. 5%.───該模具結構使鍛件的外形略去拔模斜度，材料利用率提高約12.

since the draft angle was changed, we need to lower the parting line for the mold.───由于角度改變，模具分型處要降面。

We suggest to enlarge the draft angle to help release the tool.───建議加大拔模角，以便脫模順利。

Enter a sweep distance of 0. 9 mm and a draft angle of 4 degrees.───輸入打掃距離0.9毫米和4度拔模斜度。

MOLD CENTER LINE TEXTURED SURFACE DRAFT ANGLE───模具中心線咬花面拔模角

The draft angle is changed from 1 degree to 3 degree. A───出模角度由1度改為3度。

英語使用場景

There is a shedder on the upper die of the new type of finish forging die, so that pattern draft angle of half axle of forging is small, oversize for machining is little.